Powis Parker FastBack Model 11 Especificaciones descargar pdf (Pagina 19)

FASTBACK 9 USER’S MANUAL, 203860 Rev. A 19

BINDING HARD COVER BOOKS

In addition to soft cover binding, with the Fastback® 9 binder and our

Fastback®HardcoverGuideyoucancreateprofessional-qualityhard

cover books easily and inexpensively — in less than a minute.

Ourcoversareavailableinawiderangeofsizes,colorsandnishes.

And, with the addition of our Foilfast. printer, you can apply colorful foil

printed titles and artwork to your covers and spines — in up to seven

great-looking colors with tight registration. The Fastback Hardcover

system works with the Lx-Strip, and the Lx-CP Strip.

Before binding your pages, place folded Fastback endleaves at the front

andthebackofyourprintedpages(gure42).Thefoldsshouldbeat

the spine side of your pages.

1. Set the binder to LX or Lx-CP mode according to which type of

strip you are using (see Section VII, page 16). If the machine is in

LX mode, the display will read “READY TO BIND” … “LX.” If the

machine is in LX CP STRIP mode, the display will read “READY TO

BIND” … “LX CP.”

2. Select your Lx-Strip according to your document thickness:

10-125 sheets= Narrow

125-250 sheets = Medium

(This may vary slightly depending on the paper and cover thickness.)

HINT: If you are not sure which strip width to use, simply place

your document in the binding recess and push the BIND button. The

correct width will be shown on the display.

3. Foldthestriptoa90°angle(gure43a).Makesuretheadhesive

side faces inward.

4. Place the strip into the binding recess with the adhesive side facing

up. The short side of the bent “L” should be resting against the back

wall.Slidethestripallthewaytotheright(gure43b).

5. Tamp your document cover and pages on the front atsurfaceofthe

housing so that they are straight. Place the document on top of the

stripandslidethedocumentallthewaytotheright(gure44).

6. Tap the document on the top and the left to be sure all pages are

even. Push the pages backward to ensure proper binding. Check that

thedocumentedgealignswiththeedgeofthestrip(gure45).

7. PresstheBINDbutton(gure46).Thebindingprocesswillbegin.

• NOTE: Stopping the binding process: Duringtherstseveral

seconds of the binding cycle, you can push the OPEN button

(the orange button closest to the front) to abort the whole process

and open the document clamps. Use a new binding strip when the

process resumes.

8. Assoonasthedisplayashes“REMOVEBOOK,”pickupthe

documentandplaceitagainstarearbooksupportfence(gure47).

9. Letthebounddocumentcoolforveminutes.

FOLDED

ENDLEAVES

PRINTED

PAGES

F I G U R E 42

F I G U R E 43a F I G U R E 43b

F I G U R E 44

F I G U R E 45

F I G U R E 46

F I G U R E 47

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 29 30

Comentarios a estos manuales

Sin comentarios

Powis Parker FastBack Model 11 Especificaciones Pagina 19

Comentarios a estos manuales

Relacionado con productos y manuales para Máquinas De Encuadernación Powis Parker FastBack Model 11